RX-V3200/DSP-AX3200
RX-V3200/DSP-AX3200
12. FACTORY PRESET
This menu is used to reserve and inhibit initialization of the back-up RAM. The signals are processed using EFFECT OFF.
(The L/R signal is output using ANALOG MAIN BYPASS.)
11. RS-232C
This menu is used to check transmission of the data and the flow port of the
hardware.
With the power turned off, short between pins No.2 (RxD) and No.3 (TxD) and
between pins No.7 (RTS) and No.8 (CTS) of the RS-232C terminal. (Be sure to
turn off the power when shorting pins.)
Start DIAG and select the menu.
There are two sub-menu items.
PRESET INHIBIT
(Initialization inhibited)
RAM initialization is not executed. Select this sub-menu to protect the values set
by the user.
PRESET RESERVED
(Initialization reserved)
Initialization of the back-up RAM is reserved. (Actually, initialization is executed
the next time that the power is turned on.) Select this sub-menu to reset to the
original factory settings or to reset the RAM.
CAUTION:
Before setting to the PRESET RESERVED, write down the existing preset memory content of the Tuner in a
table as shown below. (This is because setting to the PRESET RESERVED will cause the user memory content
to be erased.)
Preset group
P1
P2
P3
P4
P5
P6
P7
P8
A
B
C
D
E
•
PRESET STATIONS
STATION
FM FACTORY PRESET DATA (MHz)
PAGE
NO.
U, C
R, T, A
1
87.5
87.5
2
90.1
90.1
3
95.1
95.1
A/C/E
4
98.1
98.1
5
107.9
108.0
6
88.1
88.1
7
106.1
106.1
8
107.9
108.0
STATION
AM FACTORY PRESET DATA (kHz)
PAGE
NO.
U, C, R, T
A
1
630
630
2
1080
1080
3
1440
1440
B/D
4
530
531
5
1710
1611
6
900
900
7
1350
1350
8
1400
1404
28
TxD/RxD DATA
The sub-menu is used to check transmission of the test data. “OK” appears when
the data is transmitted properly and “NG” when it is not.
In this mode, NULL command transmission is continued after the test command
is transmitted.
HARD FLOW
This sub-menu is used to check operation of the flow port of the hardware. “OK”
appears when the check result is satisfactory and “NG” when it is not.
RxD
RTS CTS
TxD
1
2
3
6
7
8
9
4
5
