RX-V3200/DSP-AX3200
RX-V3200/DSP-AX3200
CB936
CB503
CB505
CB509
CB359
CB360
Rubber sheet
and cloth
FUNCTION P.C.B.
DSP P.C.B.
VIDEO (7) P.C.B.
VIDEO (6) P.C.B.
VIDEO (5)
P.C.B.
Extension cable (AAX30610)
M
M
J
N
N
O
P
P
P
POWER (1) P.C.B.
MAIN (2) P.C.B.
Support R
Support
Support
Rear Panel
K
10. Removal of MAIN (2) P.C.B.
a. Remove 2 screws (
J
) and 1 screw (
K
)*
2
. (Fig. 8)
b. Remove 5 screws (
L
) and then remove the Rear
Panel. (Fig. 4)
c. Remove 2 screws (
M
) and then remove the Support R.
(Fig. 8)
d. Remove 4 screws (
N
) and then remove the MAIN (2)
P.C.B.. (Fig. 8)
*
2
: R, T models only
11. Removal of POWER (1) P.C.B.
a. Remove 5 screws (
O
) and then remove the Support.
(Fig. 8)
b. Remove 3 screws (
P
) and then remove the POWER
(1) P.C.B.. (Fig. 8)
11
Fig. 8
9. Removal of VIDEO (6), VIDEO (7), and FUNCTION
P.C.B.s
a. Remove CB359, CB360, CB503, CB505, CB509 and
CB936. (Fig. 6)
b. Remove 10 screws (
I
). (Fig. 4)
c. Remove VIDEO (6), VIDEO (7), and FUNCTION
P.C.B.s. (Fig. 7)
When checking the P.C.B.:
• Put the rubber sheet and a cloth over the equipment.
Then place the P.C.B. upside down on the cloth and
check it. (Fig. 7)
• Connect VIDEO (5) and FUNCTION P.C.B.s by
using the extension cable (AAX30610) for the P.C.B.
check. (Fig. 7)
• Reconnect all cables (connectors) that have been
disconnected.
• The P.C.B. removed from the rear panel does not
work because its grounding is loose. Be sure to
connect the ground of each P.C.B. to the chassis or
GND with a jumper wire or the like.
Fig. 6
Fig. 7
