Example 3) Using cascade mode to add MTX input channels (analog connection)
MTX Setup Manual
69
In this example, make the settings shown in the above illustration. Clicking a cross point (a square area) or dragging
cross points will switch it on/off. If you right-click on a cross point, a context menu appears. You can select [All OFF]
to turn off all cross points. The cross point shows the send level as the amount of green.
With these settings, all input signals other than the microphone at the chairman’s seat (CH8 of ID=1) are handled in the
same way. To give the microphone at the chairman’s seat higher priority than the other signals, it is assigned to 1
st
Pri-
ority in the following “ZONE” screen. When CH8 is turned on in MATRIX, the signal from the matrix (attenuated) will
be combined with the signal from Priority, and output together.
For the input channel faders in the lower left of the screen, the grayed-out faders show input levels, and the other faders
show input channel send levels. Grayed-out faders cannot be operated in this screen.
PRIORITY
DUCKER
ANC
AMBIENT
SOURCE
From INPUT CHANNEL POST ON 1-8
*1 From YDIF IN 1-16
From ANC BUS 1-2
From STEREO INPUT CHANNEL POST ON 1L-3R
ZONE 1-8
ZONE OUT
To YDIF
OUTPUT
PATCH
MIX
MIX
2nd PRIORITY
1st PRIORITY
ANC
PRIORITY
SOURCE
PRIORITY
SOURCE
From DIRECT INPUT POST ON 9-16
8
PRIORITY
DUCKER
METER
ON
D
C
A
MASTER
LEVEL
GR
GR
AMBIENT
METER
To other MTXs
*1 DISTRIBUTION MODE only
Priority signal flow
