Periodic maintenance and adjustment
7-12
1
2
3
4
5
6
7
8
9
10
11
12
TIP
Make sure that the O-ring is properly
seated.
6. Install the new oil filter cartridge
with an oil filter wrench, and then
tighten it to the specified torque
with a torque wrench.
7. Install the engine oil drain bolt and
its new gasket, and then tighten
the bolt to the specified torque.
8. Refill with the specified amount of
the recommended engine oil, and
then install and tighten the oil filler
cap.
TIP
Be sure to wipe off spilled oil on any
parts after the engine and exhaust sys-
tem have cooled down.
NOTICE
ECA11621
In order to prevent clutch slip-
page (since the engine oil also
lubricates the clutch), do not
mix any chemical additives. Do
not use oils with a diesel speci-
fication of “CD” or oils of a high-
er quality than specified. In
addition, do not use oils labeled
“ENERGY CONSERVING II” or
higher.
Make sure that no foreign mate-
rial enters the crankcase.
9. Start the engine, and then let it idle
for several minutes while checking
1. O-ring
1
1. Torque wrench
Tightening torque:
Oil filter cartridge:
17 N·m (1.7kgf·m, 12 lb·ft)
Tightening torque:
Engine oil drain bolt:
23 N·m (2.3 kgf·m, 17 lb·ft)
1
Recommended engine oil:
Full synthetic
10W-40
Oil quantity:
Oil change:
3.90 L (4.12 US qt, 3.43 Imp.qt)
With oil filter removal:
4.10 L (4.33 US qt, 3.61 Imp.qt)
BW8-9-E0_1.book 12 ページ 2016年12月13日 火曜日 午前10時39分
Содержание MT-10 SP 2016
Страница 116: ...BW8 9 E0_1 book 3...
Страница 117: ...BW8 9 E0_1_Euro_E_Hyoshi indd 3 2016 12 13 11 10 32...