MG16/6FX
35
2-18. PHANTOM
Connect a 10k
Ω
load resistance between the pin 1 and 2 of the MIC and short-circuit between the pin 2 and 3.
Turn on the PHANTOM switch(LED shall light) and the voltage between pin 1 and 2 shall be 35 +/-3V.
2-19. DIGITAL EFFECT
Set the CH1 as follows and feed -40dBu signal to CH1 MIC.
GAIN VR,AUX1 VR,AUX2 VR:
MIN
Fader,EFFECT VR:
MAX
ON,PFL,1-2,3-4 switch:
OFF
When setting EFFECT RTN fader and VR to MAX and each switch(ON,PFL,1-2,3-4) to ON,the output level shall be within the
range specified the Table 2.19.1.
Feed no signal and set the CH EFFECT level control to MIN and PROGRAM select switch to 3(HALL 3).
The noise level of “ST OUT L/R” shall be less than -50dBu.
(Noise is measured with a 12.7kHz -6dB/octave low pass filter.)
Feed music source and check the DIGITAL EFFECT by listening to it.
*1 Each program (1-16) shall be measured.
Table 2.19.1 [dBu]
OUTPUT
ST L OUT
ST R OUT
GROUP1-4
AUX1,2
C-R OUT L
C-R OUT R
ST L OUT
ST R OUT
PROGRAM select switch
9: VOCAL ECHO 1 MIN
1: HALL 1
: *1
16: VOCAL REVERB 4
PARAMETER
MIN
MAX
OUTPUT level
+4.5 +/-5
+0.5 +/-5
-9 +/-30