MG166CX-USB/MG166CX/MG166C-USB/MG166C
45
PFL switch
ON when taking measurement only / OFF otherwise
1-2, 3-4 switch
ON when taking measurement only / OFF otherwise
ST switch
ON when taking measurement only / OFF otherwise
Channel fader
Maximum
• ST INPUT (13/14, 15/16)
EQ (HIGH, LOW) GAIN control
CENTER
AUX1, AUX2, AUX3 level control
Maximum
(MG166C-USB, MG166C)
AUX1, AUX2, EFFECT level control
Maximum
(MG166CX-USB, MG166CX)
AUX2 PRE switch
OFF (POST)
BAL control
L (turned counterclockwise fully)
ON switch
ON (indicator should light) when taking measurement only
/ OFF otherwise
PFL switch
ON when taking measurement only / OFF otherwise
1-2, 3-4 switch
ON when taking measurement only / OFF otherwise
ST switch
ON when taking measurement only / OFF otherwise
Channel fader
Maximum
• DIGITAL EFFECT (MG166CX-USB, MG166CX)
PROGRAM dial
1
PARAMETER control
Minimum
AUX1, AUX2 level control
Maximum when taking measurement only / MIN. otherwise
ON switch
ON (indicator should light) when taking measurement only
/ OFF otherwise
PFL switch
ON when taking measurement only / OFF otherwise
1-2, 3-4 switch
ON when taking measurement only / OFF otherwise
ST switch
ON when taking measurement only / OFF otherwise
EFFECT RTN fader
Maximum when taking measurement only / MIN. otherwise
• MASTER control
GROUP1-2, 3-4 Master fader (STEREO)
Maximum
GROUP1-2, 3-4 TO ST ASSIGN switch
OFF
STEREO Master fader (STEREO)
Maximum
AUX1, AUX2, AUX3 SEND Master level control
Maximum
(MG166C-USB, MG166C)
AUX1, AUX2, EFFECT SEND Master level control
Maximum
(MG166CX-USB, MG166CX)
RETURN TO AUX1, AUX2 ST level control
Maximum
MONITOR/PHONES level control
Maximum
STEREO/GROUP switch
STEREO (OFF)
1-2/3-4 switch
1-2 (OFF)
2TR IN/USB level control
Minimum
TO STEREO/TO MONITOR switch
OFF (TO STEREO)
• OTHERS
PHANTOM switch
OFF
2-3
The input signal should be 1 kHz sine wave unless otherwise specified.
2-4
The input signal impedance should be 150
Ω
. (Balance input)
2-5
Power indicator
When turning on the power, check the power indicator lights up.
2-6
Gain
With controls set as specified in the section 2-2, check the output levels are in the range specified in the table 2-6-1 to 2-6-
6.