MG166CX-USB/MG166CX/MG166C-USB/MG166C
49
2-17-2 RATIO
Increase the input level by +10 dB and check the output level obtained at INSERT OUT 1-6 is within the range specified in the
table 2-17-2 compared with the output level specified in the table 2-17-1.
Table 2-17-2
Note:
• Distortion should be measured with a 30 kHz low pass filter.
2-17-5 Attack Time and Release Time
With the condition specified in the section 2-17-2, check the attack time and the release time of the output obtained at INSERT
OUT 1-6 is within the range specified in the table 2-17-5.
Table 2-17-5
Notes:
• Attack time: restoration time (at 90 %) after
changing the input level from -66 dBu to -56
dBu. (Fig. 2-17-5)
• Release time: restoration time (at 90 %) af-
ter changing the input level from -56 dBu
to -66 dBu. (Fig. 2-17-5)
Fig. 2-17-5
2-17 COMP
2-17-1 GAIN
With controls set as specified in the section 2-2, set the COMP control of channels 1-6 to maximum.
Then check the output level obtained at INSERT OUT 1-6 is within the range specified in the table 2-17-1.
Table 2-17-1
CH INPUT 1-6
MIC
INPUT LEVEL
-65 dBu
COMP control
Max.
INSERT OUT 1-6
+3
±
2 dBu
CH INPUT 1-6
MIC
INPUT LEVEL
-55 dBu
INSERT OUT 1-6
+3.5
±
1 dBu
2-17-3 Frequency Characteristic
With the condition specified in the section 2-17-2, set the signal frequency to 20 Hz and 20 kHz and check the output level
obtained at INSERT OUT 1-6 is within the range of
±
3 dB compared with the 1 kHz (0 dB).
2-17-4 Distortion
With the condition specified in the section 2-17-2, set the signal frequency to 20 Hz, 1 kHz and 20 kHz and check the distortion
is less than the value specified in the table 2-17-4.
Table 2-17-4
Input Frequency
20 Hz
1 kHz
20 kHz
Distortion
5.0 %
1.0 %
1.0 %
Attack Time
Release Time
INSERT OUT
15 ms - 35 ms
170 ms - 420 ms
ATTACK TIME
90%
100%
90%
100%
Restoration Time
Restoration Time
RELEASE TIME
Sine wave
Sine wave
Rectangular wave
