Yamaha FJR13AY 2009, Руководство по обслуживанию

Страница: 692 / 744

YCC-S (Yamaha Chip Controlled-Shift) SYSTEM (FJR13AE only)
8-209
TIP
If the main switch is turned to “OFF”, the fault code number will disappear from the display and will not
be displayed again when the main switch is turned back to “ON”. Therefore, use the engine stop switch
to stop the engine, not the main switch. If the fault code number has disappeared, activate the diagnos-
tic mode and select diagnostic code No. Sh_ _61. The fault code numbers can be confirmed in the mal-
function history.
TIP
If the main switch is turned to “OFF”, the fault code number will disappear from the display and will not
be displayed again when the main switch is turned back to “ON”. Therefore, use the engine stop switch
to stop the engine, not the main switch. If the fault code number has disappeared, activate the diagnos-
tic mode and select diagnostic code No. Sh_ _61. The fault code numbers can be confirmed in the mal-
function history.
Fault code No. Sh_ _45 Symptom Shift operation and gear position do not match.
Order Item/components and probable
cause
Check or maintenance job Reinstatement
method
1 Shift rod • Check the shift rod pin hole lo-
cation.
• Check the shift rod groove loca-
tion.
• Adjust or replace if defective.
Refer to “CHECKING THE
SHIFT ROD” on page 5-75 and
“INSTALLING THE SHIFT AC-
TUATOR” on page 5-77.
Turning the
main switch to
“OFF”.
See NOTE.
2 Defective shift actuator. • Replace shift actuator.
3 Confirm the operation of the main
switch after repairing the malfunction
or correcting the cause. • Execute the diagnostic mode.
(Code No. Sh_ _64)
Fault code No. Sh_ _46 Symptom Engine speed and gear position sensor signal
do not match while vehicle is driven.
Order Item/components and probable
cause
Check or maintenance job Reinstatement
method
1 Gear position setting. • Execute the diagnostic mode.
(Code No. Sh_ _65)
Turning the
main switch to
“OFF”.
See NOTE.