Yamaha FJR1300A(X), Руководство по обслуживанию

Страница: 572 / 754

FUEL INJECTION SYSTEM
8-95
Fault code No. 43 Symptom The ECU is unable to monitor the battery voltage (an open
or short circuit in the line to the ECU).
Diagnostic code No. d:09 Fuel system voltage
Order Item/components and probable
cause
Check or maintenance job Reinstatement
method
1 Connections
• Relay unit coupler
• Wire harness ECU coupler
• Front cowling wire harness coupler • Check the coupler for any pins
that may be pulled out.
• Check the locking condition of
the coupler.
• If there is a malfunction, repair it
and connect the coupler se-
curely.
Starting the en-
gine and oper-
ating it at idle.
2 Open or short circuit in the wire har-
ness and/or front cowling wire har-
ness. • Repair or replace if there is an
open or short circuit.
• Between relay unit coupler and
ECU coupler.
(blue/yellow–blue/yellow)
(red/blue–red/blue)
• Between relay unit coupler and
engine stop switch coupler.
(red/black–red/black)
3 Malfunction or open circuit in fuel
pump relay. • Execute the diagnostic mode.
(Code No.d:09)
• Replace if defective.
• If there is no malfunction with
the fuel pump relay, replace the
ECU.
Fault code No. 44 Symptom An error is detected while reading or writing on EEPROM
(CO adjustment value).
Diagnostic code No. d:60 EEPROM fault cylinder No.
Order Item/components and probable
cause
Check or maintenance job Reinstatement
method
1 Malfunction in ECU. • Set the faulty cylinder’s exhaust
gas volume.
1. Execute the diagnostic mode
(Code No.d:60) to check the
faulty cylinder number. (If
multiple cylinders are defec-
tive, the numbers of the
faulty cylinders are displayed
alternately at 2-second inter-
vals.)
2. Execute the CO adjustment
mode and set the exhaust
gas volume of the faulty cyl-
inder to “0”.
• Replace ECU if it does not re-
cover from the malfunction.
Turning the
main switch to
“ON”.
(Readjust the
exhaust gas
volume after it
is reinstated.)