Yamaha FJR1300A(X), Руководство по обслуживанию

Страница: 163 / 754

ENGINE
3-24
3. Install:
• Air filter case
• T-bar
Refer to “GENERAL CHASSIS” on page 4-1.
• Fuel tank
Refer to “FUEL TANK” on page 7-1.
• Rider seat
Refer to “GENERAL CHASSIS” on page 4-1.
EAS21080
CHECKING THE EXHAUST SYSTEM
The following procedure applies to all of the ex-
haust pipes and gaskets.
1. Remove:
• Side cowlings
Refer to “GENERAL CHASSIS” on page 4-1.
2. Check:
• Exhaust pipe assembly “1”
• Mufflers “2”
Cracks/damage
→
Replace.
• Gasket “3”
Exhaust gas leaks
→
Replace.
3. Check:
• Tightening torque
• Exhaust pipe assembly nuts “4”
• Exhaust pipe assembly bolts “5”
• Exhaust pipe assembly and muffler bolts “6”
• Muffler bolts “7”
4. Install:
• Side cowlings
Refer to “GENERAL CHASSIS” on page 4-1.
EAS21110
CHECKING THE COOLANT LEVEL
1. Stand the vehicle on a level surface.
NOTE:
• Place the vehicle on the centerstand.
• Make sure the vehicle is upright.
2. Remove:
• Left side panel
Refer to “GENERAL CHASSIS” on page 4-1.
3. Check:
• Coolant level
The coolant level should be between the min-
imum level mark “a” and maximum level mark
“b”.
Below the minimum level mark
→
Add the
recommended coolant to the proper level.
T
R
.
.
Exhaust pipe assembly nut
20 Nm (2.0 m·kg, 14 ft·lb)
Exhaust pipe assembly bolt
17 Nm (1.7 m·kg, 12 ft·lb)
Exhaust pipe assembly and muf-
fler bolt
20 Nm (2.0 m·kg, 14 ft·lb)
Muffler bolt
25 Nm (2.5 m·kg, 18 ft·lb)
1
3
(8)
2
2
4
6
5
7
7
6
5
b
a