Yamaha F50D, Руководство по обслуживанию

Страница: 327 / 372

9-48
0
1
2
3
4
5
6
7
8
9
10
A
Assembling the tilt cylinder
1. Install the free piston
1
and a new O-
ring
2
into the trim cylinder
3
, and then
install the snap ring
4
.
2. Install the trim cylinder base
5
, springs
6
, and plate
7
into the trim cylinder
3
,
and then install the circlip
8
.
3. Hold the PTT unit
9
in a vise using alu-
minum plates
a
on both sides.
4. Add the recommended fluid to the first
level at the bottom of tilt cylinder.
5. Install the balls
0
into the trim cylinder
3
, and then install the trim cylinder
3
into the tilt cylinder
q
.
TIP:
Apply grease to the balls to prevent them
from falling out of the cylinder.
6. Install the tilt cylinder end screw
w
, and
then tighten it to the specified torque.
7. Fully extend the PTT ram, and then add
sufficient recommended fluid to the cor-
rect level.
8. Install a new O-ring
r
and the reservoir
cap
t
.
Trim cylinder end screw
b
:
80 N·m (8.0 kgf·m, 59.0 ft·lb)
2
1
4
3
5
3
6
7
8
6
9
a
a
Recommended PTT fluid: ATF Dexron
2
Cylinder-end screw wrench
e
:
90890-06568
Tilt cylinder end screw
w
:
90 N·m (9.0 kgf·m, 66.4 ft·lb)
Recommended PTT fluid: ATF Dexron
2
0
q
3
w
e
PTT cylinder