Yamaha F40H, Руководство пользователя

Страница: 33 / 110

Components
26
specified torque.
TIP:

Steering movement is blocked when the
adjuster lever is set to the “A” position.

Check the tiller handle for smooth move-
ment when the lever is turned to the star-
board side “B”.

Do not apply lubricants such as grease to
the friction areas of the steering friction ad-
juster.
EMU26144
Power trim and tilt switch on remote
control or tiller handle
The power trim and tilt system adjusts the
outboard motor angle in relation to the tran-
som. Pressing the switch “
” (up) trims the
outboard motor up, and then tilts it up. Press-
ing the switch “
” (down) tilts the outboard
motor down and trims it down. When the
switch is released, the outboard motor will
stop in its current position.
For instructions on using the power trim and
tilt switch, see pages 56 and 59.
EMU26156
Power trim and tilt switch on bottom
cowling
The power trim and tilt switch is located on
the side of the bottom cowling. Pushing the
switch “
” (up) trims the outboard motor up,
and then tilts it up. Pushing the switch “ ”
(down) tilts the outboard motor down and
trims it down. When the switch is released,
the outboard motor will stop in its current po-
sition.
For instructions on using the power trim and
tilt switch, see page 59.
EWM01032
Use the power trim and tilt switch located
on the bottom cowling only when the boat
is at a complete stop with the engine off.
Attempting to use this switch while the
boat is moving could increase the risk of
falling overboard and could distract the
1. Nut
Nut tightening torque:
6 N·m (0.6 kgf·m, 4.4 lb·ft)
1 1 1
DN
UP
ZMU01720
6C1-9-7J-1E0.book 26 ページ ２０１９年１０月３０日 水曜日 午後２時５６分