Yamaha F40H, Руководство пользователя

Страница: 85 / 110

Maintenance
78
fastened to the transom or a stable
stand.
ECM01711
Change the engine oil after the first 20
hours of operation or 3 months, and ev-
ery 100 hours or at 1-year intervals there-
after. Otherwise the engine will wear
quickly.
To prevent spilling oil where it could cause
damage to nature, it is strongly recommend-
ed that you use an oil changer to change the
engine oil. If an oil changer is not available,
drain the engine oil by removing the drain
screw. If you are not familiar with the proce-
dure for changing the engine oil, consult your
Yamaha dealer.
(1) Put the outboard motor in an upright po-
sition (not tilted). NOTICE: If the out-
board motor is not level, the oil level
indicated on the oil dipstick may not
be accurate.
[ECM01862]
(2) Start the engine. Warm it up and keep
the idle speed for 5-10 minutes.
(3) Stop the engine and leave it for 5-10
minutes.
(4) Remove the top cowling.
(5) Remove the oil filler cap. Pull out the dip-
stick and use the oil changer to extract
the oil completely.
TIP:
When using an oil changer, skip steps 6 and
7.
(6) Prepare a suitable container that holds a
larger amount than the engine oil capac-
ity. Remove the drain screw and gasket
while holding the container under the
drain hole. Let the oil drain completely.
Wipe up any spilled oil immediately.
TIP:
If the oil does not drain easily, change the tilt
angle or turn the outboard motor to port and
starboard to drain the oil.
(7) Put a new gasket on the oil drain screw.
Apply a light coat of oil to the gasket and
install the drain screw.
ZMU03659
1. Oil changer
1. Drain screw
2. Gasket
1
ZMU061 8 7
1
2
ZMU07927
6C1-9-7J-1E0.book 78 ページ ２０１９年１０月３０日 水曜日 午後２時５６分