Yamaha CROSS CONNECT Series, Инструкция по сборке

Страница: 13 / 18

INSTALLING THE INCLUDED PARTS
– 11 –
79
12. Installing the display unit’s button cell bat-
tery
Loosen the bolts
a
and remove the display unit
b
from the bracket
c
.
Turn the button cell battery cover
d
on the back
of the display unit
b
in direction
e
, remove it,
then install the button cell battery
1
.
Mount the button cell battery cover
d
, then turn
it in direction
f
until it locks.
After installing the button cell battery, install the
display unit onto the bracket following the
removal procedure in reverse order.
Peel off the protective film after installing.
13. Adjusting the display unit’s time
A. Press the power switch
a
to turn on the power.
B. Press and hold the function select switch
b
(2
seconds or longer) until the function display
c
switches to the main menu display.
C. Press the “
▼
” assist mode switch
d
, display
“TIME ADJ” on the main menu display, then
press the function select switch
b
to set.
D. The hours value increases when the “
▲
” assist
mode switch
f
is pressed while the “Hour” sec-
tion of the clock
e
is flashing.
The hours value decreases when the “
▼
” assist
mode switch
d
is pressed.
Press the function select switch
b
to set the
hours.
a
c b
Tightening torque 2.0 N·m (0.20 kgf·m, 1.5 lb·ft)
d
e f
1
b
g
1
Button cell battery 1 B
8
Install the button cell battery with the plus
(+) mark facing upward.
8
Check that the O-ring
g
is properly
installed.
NOTICE
d
b a
c
d
f
b
e