Yamaha CROSS CONNECT Series, Инструкция по сборке

Страница: 7 / 18

INSTALLING THE INCLUDED PARTS
– 5 –
79
Align the holes in the front wheel
1
with the
holes in the fork end and install the front wheel
1
.
Install it in such a way that the disc rotor
c
does
not touch the disc pad.
Put the lever
d
of the front axle
2
down in the
direction in which the stamp “OPEN” is visible
and check that the collar
e
is open.
Install the front axle
2
to the fork end holes
from the left side of the bicycle.
TIP
8
Even if the collar
e
of the front axle
2
is
inserted with the collar open, it will close when
pressed in.
8
When the collar
e
is closed, turn the nut
f
approximately 1/8 turn counterclockwise while
keeping it pressed in; the collar will then open.
Check that the collar
e
of the front axle
2
goes
through the hole in the right side of the fork end
and that the collar is actually open.
Turn the nut
f
while keeping it pressed to pre-
vent the lever
d
from turning, and tighten it until
there is a little resistance.
Determine the position in which the lever
d
is to
be fastened, lower it in the direction in which the
stamp “CLOSE” is visible, then fasten it.
a
c
1
2
e
f
d
2
1
Front wheel 1
2
Front axle 1 B
d
e
f
d