AW2816
32
CD-RW drive settings
Insert the jumper (included with the CD-RW drive)
into the jumper switch on the rear panel of the CD-
RW drive to set your CD-RW drive to function as a
SLAVE unit. The AW2816 will not start up if the CD-
RW is set to a mode other than SLAVE.
• If you are installing a CD-RW drive manufac-
tured by Yamaha, it will be set to SLAVE when
shipped from the factory, so you do not need to
change the setting.
For details on this setting, refer to the manual that
came with your CD-RW drive.
* Note that the cover panel of the AW2816 cannot be
attached to a CD-RW drive with a lid-type tray. The
AW2816’s cover panel can be attached to a CD-RW
drive with a tray of the following dimensions.
CSEL
SLAVE
MASTER
Set to SLAVE
Jumper switch
Jumper
Maximum 138 mm
INSTALLING A CD-RW DRIVE
Содержание AW2816
