Yamaha ACD1, Справочное руководство

Страница: 2 / 25

ACD1 Reference Manual
2
Contents
Introduction............................................. 3
About the documentation .................................3
Supported amplifiers .........................................3
Setup ...................................................................3
Terms ..................................................................4
Controls and Connectors ...................... 5
Front Panel .........................................................5
Rear Panel ..........................................................6
Panel operations .................................... 7
Basic operation ..................................................8
Scene (“1. Scene”)...........................................10
Recalling a scene (“1. Scene”
➝
“Recall”) ............ 10
Storing a scene (“1. Scene”
➝
“Store”) ................. 10
Controlling an amplifier (“2. Amp Control”)..11
Power on/standby
(“2. Amp Control”
➝
“Standby”) ....................... 11
Mute (“2. Amp Control”
➝
“Mute”)......................... 11
Attenuator value adjustment
(“2. Amp Control”
➝
“Attenuation”) .................. 11
Amplifier output monitor
(“3. Output Monitor”) .......................................12
Amplifier output (“3. Output Monitor”) ................... 12
Device setup (“4. Device Setup”) ...................12
Device ID setting
(“4. Device Setup”
➝
“Device ID”) ................... 12
View ACD1 name
(“4. Device Setup”
➝
“Device Label”) .............. 12
Identify (“4. Device Setup”
➝
“Identify”) ................ 13
Utility (“5. Utility”) ............................................13
Backup battery check (“5. Utility”
➝
“Battery”) ...... 13
Version indication (“5. Utility”
➝
“Firmware Ver.”) .. 13
LCD backlight (“5. Utility”
➝
“LCD Backlight”) ....... 14
Restricting panel operations
(“5. Utility”
➝
“Panel Operation”) ..................... 14
Enabling scene recall operations from the panel
(“5. Utility”
➝
“Scene Recall”) .......................... 14
Enabling scene recall operations via
EMG commands
(“5. Utility”
➝
“EMG Scene Setup”) ................. 15
LAST MEMORY RESUME setting
(“5. Utility”
➝
“Last Mem. Resume”) ................ 15
Clock setting (“5. Utility”
➝
“Clock”)....................... 15
GPI IN calibration
(“5. Utility”
➝
“GPI Calibration”) ....................... 16
Network settings (“6. Network Setup”) ..........16
IP Address Mode setting
(“6. Network Setup”
➝
“IP Address Mode”) ..... 16
IP Address setting
(“6. Network Setup”
➝
“IP Address”) ............... 16
Checking the MAC address
(“6. Network Setup”
➝
“MAC Address”) .......... 16
Port settings for an external controller
(“6. Network Setup”
➝
“IP Ctrl Port #”) ............ 17
Initializing the ACD1 ........................................17
Connector wiring .................................. 18
Euroblock plug connection.............................18
GPI connector ..................................................19
FAULT OUTPUT connector .............................20
Appendix ............................................... 21
Display messages ............................................21
List of supported characters ..........................21
Troubleshooting...............................................22
Specifications...................................................22
Control I/O ........................................................23
Pin Assignment ................................................23
MONITOR/REMOTE............................................. 23
DATA PORT .......................................................... 23
Dimensions.......................................................24