Trim Assist Center
45
TIP:
To configure and enable “Set CNTR Trim”
function, “Set ALL Trim” setting has to be
completed first.
1.
From the “Engine Menu”, select “Trim
Assist”.
2.
Select the position (1–5) you are setting.
TIP:
• The engines must not be running when the
desired speed and percentage of trim are
entered into the gauge. It is recommended
that the boat be water-tested to determine
the optimum trim positions at specific
engine speeds for your operating conditions
prior to entering these settings.
• During testing, record the “Current” speed
and percentage of trim information for later
entry into Positions 1–5.
• It is required to enter engine speed and
percentage of trim data in all five positions.
Engine speed for Position 1 is automatically
set for “Idle”.
3.
Tap “Set RPM” to move to the “Trim
Assist-Set RPM” menu.
4.
Enter your preferred engine speed. Tap
“Done” to confirm.
5.
Tap “Set ALL Trim” to move to the “Trim
Assist-Set Trim” menu.
6.
Set the desired amount of trim angle in
percentage. Tap “Done” to confirm.
7.
From the “Trim Assist”, select “Set CNTR
Trim”.
DEC_OM(QUINT)_EN.book 45 ページ ２０２１年６月２５日 金曜日 午前９時１６分
Downloaded from
