Operation and handling requirements
91
(6) Remove the engine oil filler cap.
1
Engine oil filler cap
(7) Slowly add engine oil.
(8) Wait approximately 5 minutes to allow
the engine oil to settle, and then check
the engine oil level again.
(9) Repeat steps 3–8 until the engine oil is at
the proper level.
(10) Install the engine oil filler cap.
(11) Repeat the checking oil level procedure
for the other engine.
(12) Close the engine hood.
Draining the bilge water
NOTICE
Do not run the engines at full throttle
when bilge water remains in the engine
compartment. The bilge water can
splash into the engines, which can result
in severe damage.
Be sure all drain plugs are tightened be-
fore operating your boat. Otherwise,
water may flood the boat and cause it to
submerge.
Draining the bilge water on land
This model is equipped with multiple drain
plugs.
Bilge water from the various compartments
flows through drain passages and collects in
the bottom of the hull. The bilge water can be
drained from the boat by removing the hull
drain plugs.
Ski locker
1
Drain plug
1
1
SportsBoat_F5K10.book Page 91 Tuesday, September 8, 2020 11:29 AM
Downloaded from