Operation
107
1
“BLOWER” switch
(4) Attach the engine shut-off cord (lanyard)
to your PFD. Install the clip onto the en-
gine shut-off switch by pushing the clip
groove over the nut beneath the knob.
Be sure the cord is not wrapped around
the steering wheel or tangled in the con-
trols.
WARNING! Check that the en-
gine shut-off cord (lanyard) is
attached correctly. If the engine shut-
off cord (lanyard) is not attached cor-
rectly, it may not pull free when the
operator falls off, allowing the boat to
continue to run and cause an acci-
dent.
1
Engine shut-off switch
2
Clip
3
Engine shut-off cord (lanyard)
TIP:
The engines will not start when the clip is re-
moved from the engine shut-off switch.
(5) Put the remote control levers in the neu-
tral position. The starter motors will not
operate unless the remote control levers
are in neutral.
(6) Turn the main switch key to the on posi-
tion.
(7) Push the “START/STOP” buttons and re-
lease them when the engines start. If the
engines do not start after 5 seconds of
cranking, release the buttons. Wait at
least 15 seconds before trying to start
the engines again.
NOTICE:
If the start-
er motors are engaged continuously
for more than 5 seconds, the start bat-
tery will become quickly discharged
and it will be impossible to start the
engines. The starter motors may also
be damaged if they are engaged con-
tinuously for more than 5 seconds.
1
3
1
2
SportsBoat_F5K10.book Page 107 Tuesday, September 8, 2020 11:29 AM
Downloaded from