Yamaha 2006 FJR1300AS, Руководство по обслуживанию

Страница: 119 / 150

YCC-S (Yamaha Chip Controlled-Shift) SYSTEM
– 110 –
NOTE:
If the main switch is turned to “OFF”, the fault code number will disappear from the display and will not
be displayed again when the main switch is turned back to “ON”. Therefore, use the engine stop switch
to stop the engine, not the main switch. If the fault code number has disappeared, activate the diagnos-
tic mode and select diagnostic code No. Sh_ _61. The fault code numbers can be confirmed in the mal-
function history.
NOTE:
If the main switch is turned to “OFF”, the fault code number will disappear from the display and will not
be displayed again when the main switch is turned back to “ON”. Therefore, use the engine stop switch
to stop the engine, not the main switch. If the fault code number has disappeared, activate the diagnos-
tic mode and select diagnostic code No. Sh_ _61. The fault code numbers can be confirmed in the mal-
function history.
Fault code No. Sh_ _26 Symptom Abnormal clutch movement is detected during
check when main switch is turned to “ON”.
Order Item/components and probable
cause
Check or maintenance job Reinstatement
method
1 Clutch fluid • Check for clutch fluid leakage.
• Check the clutch fluid level.
Refer to “CHECKING THE
CLUTCH FLUID LEVEL” on
page 31.
Turning the
main switch to
“OFF”.
See NOTE.
2 Air in hydraulic clutch system • Check the clutch stroke.
• Bleed the hydraulic clutch.
Refer to “BLEEDING THE HY-
DRAULIC CLUTCH SYSTEM”
on page 31.
Fault code No. Sh_ _27 Symptom Diagnosis mode is activated at engine start-up.
Order Item/components and probable
cause
Check or maintenance job Reinstatement
method
1 YCC-S test coupler • Check that the test coupler
adapter is not connected.
Refer to “DIAGNOSTIC MODE”
on page 95.
Turning the
main switch to
“OFF”.
See NOTE.
2 Short circuit in wire harness. • Repair or replace if there is a
short circuit.
• Between YCC-S test coupler
and MCU (motor control unit)
coupler.
(blue/yellow–blue/yellow)