7-5
FUEL INJECTION SYSTEM
FI
“Engine runs irregularly.” or “Engine trouble warning light is illuminated.”
* Engine trouble warning light may not be illuminated even if the engine runs irregularly.
When the engine trouble warning light is illumi-
nated
Checking the self-diagnostic fault code number:
Check the self-diagnostic fault code number dis-
played on the meter.
Specifying the malfunctioned system:
Specify the malfunctioned system by referring to
the Fail-safe actions table.
Presuming the cause:
Presume the malfunction cause by referring to the
Diagnostic monitoring code table.
Checking and repaining the presumed place of
malfunction.
Diagnostic
Monitoring codeNo.
YES
Diagnostic
Monitoring code No.
NONE
Check and repair in
accordance with the
“Troubleshooting de-
tails”, monitoring the
operation of sensor
and actuator in the
Diagnostic monitoring
mode (Refer to “SEN-
SOR OPERATION
TABLE/ACTUATOR
OPERATION TABLE”
in chapter 7.).
Check and repair in
accordance with the
trouble shooting de-
tails.
ECU reinstatement action:
Perform ECU reinstatement action referring to the
reinstatement method in the troubleshooting details.
Checking the meter display:
Check whether the self-diagnostic fault code num-
ber is shown after turning the main switch OFF
once, and then turning it back ON.
Erasing the melfunction history:*
Malfunction history will be stored even if the main
switch is turned OFF. To erase the malfunction his-
tory, it is required to operate to erase the malfunc-
tion history in the Diagnostic monitoring mode.
(Refer to “SENSOR OPERATION TABLE” in chap-
ter 7.)
Repair Completion
When the engine trouble warning light is not illumi-
nated
Inspecting the sensor actuator:Check the opera-
tion of following sensors and actuators in the Diag-
nostic monitoring mode (Refer to “SENSOR OP-
ERATION TABLE/ ACTUATOR OPERATION
TABLE” in chapter 7.)
01: Throttle position sensor (throttle angle)
30: Ignition coil #1
31: Ignition coil #2
36: Injector #1
37: Injector #2
48: Al system solenoid
49: In take solenoid
Malfunction of en-
gine unit
Defective sensor
or actuator
Check and repair
the inner parts of
engine referring to
the engine edition
of Chapter 5.
Check and repair
the corresponding
sensor or actuator.
* Operation when the engine trouble warning light is illu-
minated.
Displayed
again.
Not displayed
OK
NG
OK
OK
Checking the engine condition.
OK
NG
TROUBLE SHOOTING CHART
Содержание 2002 TDM900
