3/3
CAUTION
- Keep hands and fingers away from the pump during operation to avoid injury from moving parts.
- Use pump for the material suitable for the specification. Parts may be corroded and material leak
from the damaged parts can lead to environmental pollution. Also, follow handling notes (SDS) of
the manufacturer about the handling of the material used.
- Take fall-prevention measures if using a slim or light tank. Risk of falling will be increased due to
shift in center of gravity caused by change in the material level in a tank.
- Take protective measures against rainwater and dust. It is likely to lead to the pollution of the
material.
- Be very careful about the edge of the pump when you lift the pump. Your hands might be injured.
- Be very careful about your posture when installing the pump. Back injury may be caused by lifting
the pump.
- Do not touch the surfaces of the pump and the hose when pumping high-temperature material.
Risk of burns exists.
- Stop the air supply source after the end of work when not using this pump for a long time such as
nighttimes and holidays. Also, open the valve of the exhalation port and liberate pressure in the
pump and the hose. There is a possibility of polluting facilities because of the damage of the hose
and the leakage of the valve. Such a secondary disaster becomes a responsibility on the user side.
- (DR type only) Place a drum on a flat, level surface to position pump horizontally against a
ground. Operating the pump on a slope may cause a fall or tip-over due to shift in center of gravity
caused by change in the material level.
- (DR type only) Material remaining inside or on the surface of the pump may spill out by inserting
or removing the pump into/from a drum. Be very careful not to get your clothing dirty.
