6
Label Set (Procedure for each function/Lmode)
Please refer to the illusutration on the page 7 when label setting.
■
Prepare the label roll that is no labels on the fiast portion of 30cm.
■
Make sure whether switch is off. (illustration 1)
■
Plug in and connect cord. (illustration 1)
■
Make sure that switch is turned on. (illustration 2)
・
Sound peep and turn on the light.
■
Switch to L-mode. (illustration 3)
・
Push the Start Button longer and switch to the following mode accordingly.
( L-mode C-mode P-mode F-mode )
■
Pull Spare Label Holder out and take both side of Label Hold Wing to set the right position. (illustration 4)
■
Press Label Holder Lock Lever down and lift Label Holder up.
・
If press Label Holder Lock Lever down, Front Panel will be automatically opened.
■
Set label roll in the proper procedure as follows. (illustration 4)
a) Hold label roll by hand and pass label though Front Support Roller.
b) Pass label though between Removal Plate and Label Holder and take label roll on Front Support Roller.
■
Turn Wing Adjust Dial and adjust label roll until Label Hold Wing touches it. (illustration 5)
■
Turn Wing Adjust Dial back slightly and make sure that label roll can rotate smoothly. (illustration 5)
■
Set label roll like Label Hold Internal Wing touches paper roll and Label Hold External Wing touches the
core of label. (illusration 5)
■
Insert the point of label into the inlet of Front Panel until it reaches to Feed Roller. (illsutrration 5)
■
While holding the point of label inserted into the inlet of Front Panel, press FWD button several taimes.
■
Make sure that label feeds properly and release Label Holder Lock Lever. (illutration 7)
■
Make sure that Feed Roller works properly while pressing FWD button several times.
■
When label roll comes properly from the machime, insert the point of the label into Backing Paper
Release Bar. (illustration 8)
・
If it is rather difficult to insert into Backing Paper Release Bar, take the right position to make it easy.
■
Press FWD button several times to make sure that Backing Paper Release Bar works properly.
・
In the case of label roll wound weakly or improperly, please refer to "Other Function" on the page 11.
■
Press FWD button several times and make sure that label is removed properly from Removal Plate.
(illustration 9)
・
In the case that label doesn't remove from the paper, please refer to "Other Function" on the page 11.
■
When pressing FWD button several times and take the label removed, make sure that the paper
removed goes through Removal Plate properly. (illustration 10)
■
Take the right position for sensor under label.
■
Take the label removed on Remobal Plate.
■
In order to set the label position as you prefer, please refer to "Mode Setting" on the page 8.
Please note that the label itself doesn't go into the machine.
It may cause the origin of the malfunction.
