Yaesu FTM-6000R, Руководство по эксплуатации

Страница: 35 / 48

33
Changing the Frequency Step
The DIAL knob rotation frequency step may be changed. Normally, use the factory de-
fault setting of “
AUTO
”.
1. Press and hold the [ F menu ] key.
2. Rotate the DIAL knob to select [ 27 STEP ], then press
the DIAL knob.
3. Rotate the DIAL knob to set the frequency step.
4. Press the DIAL knob to complete the setting.
• The default setting, of the frequency step is set to
“AUTO”, which automatically provides a suitable
frequency step according to the frequency band.
• The frequency steps that can be selected depend on
the frequency band.
Changing the Transmit Power Level
The transmit power level can also be changed using the function list.
1. Press the [
F menu ] key.
2. Rotate the
DIAL
knob to select [
F-30 TX PWR
], then
press the DIAL knob.
With the factory default setting, it is registered in the
“Function list” that is displayed when you press the
[ F menu ] key.
3. Rotate the DIAL knob to select the transmit power
output.
“ LOW ”→“ MID ”→“ HIGH ”
4. Press the DIAL knob to complete the setting.
Display of PO meter during transmission
HIGH MID LOW
50 W 25 W 5 W
*: The factory setting is “HIGH”.
• When the “TX PWR” function is assigned to the [P2], [P2], [P3] or [P4] key of the
microphone, the assigned key may be used as the Transmit Power Level select key.
1. Press and hold the [ F menu ] key.
2. Rotate the DIAL knob to select [ 14 MIC.PGM ], then press the DIAL knob.
3. Rotate the DIAL knob to select a key to assign a function [PGM.P1] / [PGM.P2] /
[PGM.P3] / [PGM.P4] then press the DIAL knob.
5. Rotate the DIAL knob to select a “TX PWR” then press the DIAL knob.
• The transmit power output can be set individually for each frequency band (144MHz or
430MHz bands) and memory channel.