Yaesu FTM-6000R, Руководство по эксплуатации

Страница: 14 / 48

12
Microphone (SSM-85D)
MIC
Speak into the microphone during transmission.
TX LED
Lights red while pressing PTT switch.
PTT
Press and hold the PTT switch to transmit, and release it to receive.
DWN
Press this button to move the frequency or memory channel lower
by one step, press and hold it to start scanning.
UP
Press this button to move the frequency or memory channel up by
one step, press and hold it to start scanning.
MUTE
Press this button to mute the receive audio. Press it again to
unmute the audio.
DTMF keypad
Press these keys during transmit to enter and send a DTMF sequence. The following operations can be
performed during receive.
0 - 9 : Enter the frequency or memory channel number.
A : Change frequency in 1MHz steps
B : Adjust the squelch level.
C : Each key press switches between PMG (Primary Memory Group) mode and memory or VFO mode.
D : Each key press switches between Function list mode and memory or VFO mode.
* : Each press switches between VFO mode and memory mode.
# : This key has the same function as the [
BAND grp
] key on the controller.
VFO mode:
Each press changes the operating frequency band:

AIR (108MHz to 137MHz)

144MHz (137MHz to 174MHz)

VHF (174MHz to 400MHz)


430MHz (400MHz to 480MHz)

UHF (480MHz to 999.995MHz)

AIR
Memory mode:
Each time the key is pressed only memory channels of the same frequency band are automatically
recalled as a group, as shown below:

ALL

AIR (108MHz to 137MHz)

VHF (137MHz to 174MHz)

UHF (400MHz to 480MHz)


Other (174MHz to 400MHz and 480MHz to 999.995MHz)

ALL
* Bands that have not been stored are not displayed.
Program keys (P1/P2/P3/P4)
The default function settings of the [P1] / [P2] / [P3] / [P4] keys are shown in the table below.
Key Function Description
P1 SQL OFF Opens the squelch (SQL off)
P2 HOME Recalls HOME channel
P3 SCN ON Starts or stops the scanning function
P4 WX (T-CALL) Switches operation to the Weather Channel Bank (T-CALL: European/Asian versions)
The functions of the [ P1 ] - [ P4 ] keys can be assigned by the following operations:
1. Press and hold the [ F menu ] key.
2. Rotate the
DIAL
knob to select [
14 MIC.PGM
], then press the
DIAL
knob.
3. Rotate the DIAL knob to select a key to assign a function [ PGM.P1 ] - [ PGM.P4 ] then press the DIAL knob.
4. Rotate the
DIAL
knob to select a function (see the table below) then press the
DIAL
knob.
Function Description
ARTS
Starts or stops the ARTS function
SCN ON
Starts or stops the scanning function
HOME
Recalls the HOME channel
RPT.SFT
Sets the repeater shift direction
RPT.REV
R e v e r s e s t h e t r a n s m i t a n d r e c e i v e
frequencies in repeater mode or split memory
Function Description
TX PWR
Selects the transmit power output level
SQL OFF
Opens the squelch (SQL OFF)
T-CALL
Transmits the T-CALL (1750 Hz)
DW
Starts or stops the Dual Watch function
WX
Switches operation to the Weather Channel
Bank