Yaesu FTM-6000R, Руководство по эксплуатации

Страница: 28 / 48

26
Scanning Function
The FTM-6000R/E supports the following scanning functions:
• VFO Scan
• Memory Channel Scan
• PMG (Primary Memory Group) Scan
• Programmable Memory Scan (PMS)
VFO Scan / Memory Scan / PMG Scan
To find frequencies where there are signals in VFO mode, memory mode or PMG mode:
1. Press the [
V/M mw ] key to switch to VFO mode or
Memory mode.
2. Press and hold the microphone [ UP ] or [ DWN ] switch
to start scanning.
• When the VFO scan is active, “VFO.SCN” appears
on the display.
• When the Memory scan is active, “MEM.SCN” ap-
pears on the display.
• When the PMG scan is active, “PMG.SCN” appears
on the display.
• If the DIAL knob is rotated while scanning is in prog-
ress, the scanning will continue up or down in fre-
quency according to the direction of the DIAL Knob
rotation.
• When a signal is received until the signal fades out.
Two seconds after the signal fades out, scanning
resumes.
3. Press the PTT* switch or [ UP ] or [ DWN ] on the
microphone to cancel the scanning.
*The transceiver will not transmit in this case.
Display during VFO scanning
Display during Memory scanning
Display during PMG scanning
• If the scan has paused on a signal, rotating the DIAL knob will cause scanning to resume
instantly.
• If the transceiver is turned OFF while scanning, when the transceiver is turned ON,
scanning will resume.
Programmable Memory scan (PMS)
This function scans only the range of frequencies between the lower and upper limits
registered in a pair of PMS Programmable Memory channels. 50 sets of PMS memory
channels (L01/U01 to L50/U50) are available.
For additional details on the Programmable Memory Scan (PMS), refer to the Advanced
Manual which may be downloaded from the Yaesu website.