Yaesu FT DX 1200, Руководство по эксплуатации

Страница: 87 / 140

Page 85
FT
DX
1200 O
PERATING
M
ANUAL
C
HECKING THE
CW M
EMORY
C
ONTENTS
1. Be sure that Break-in is still turned “ 2 ff” by the
[
BK-IN
] button.
. 3 ress the [ MONI
] button to enable the CW monitor.
3. 3 ress the
FH-2
[
1
]
a [
5
] key, whichever memory
you just recorded in. You will hear the results in the
sidetone monitor, but no
5 F energy will be transmit-
ted.
N
OTE
:
You may adjust the monitor level setting using 0 enu
item “
036 MONITOR LEVEL
”.
O
N
-T
HE
-A
IR
CW M
ESSAGE
P
LAYBACK
1. 3 ress the [ BK-IN
] button to enable transmission.
( i-
ther Full- or Semi-break-in will be engaged, depend-
ing on the setting of
0 enu item “
063 CW BK-IN
”.
. 3 ress the FH-2 [ 1
]
a [ 5
] key, depending on which
CW 0 emory 5 egister message you wish to transmit.
The programmed message will be transmitted on the
air.
N
OTE
:
If you subse T uently decide to use the “Text 0 emory”
techni T ue for memory storage, please note that a mes-
sage stored using keyer padd le input will not be trans-
ferred over when you select “Text 0 emory techni T ue”
on a particular memory register the 0 enu 0 ode Setting
is set to “
TEXT
”).
CW C
ONVENIENCE
F
EATURES
C
ONTEST
M
EMORY
K
EYER
(
U
SING THE
O
PTIONAL
FH-2 R
EMOTE
C
ONTROL
K
EYPAD
)
M
ESSAGE
M
EMORY
P
ROGRAMMING
(
U
SING YOUR
P
ADDLE
)
1. Set the operating mode to CW.
. Set the [ BK-IN
] button to “
2 ff”.
3. Turn the inter nal ( lectronic . eyer “ 2 n”.
4. 3 ress the [ MEM
] key on the
FH-2 . $ blinking “ REC ”
icon will appear in the display.
. 3 ress any of the FH-2 keys numbered [ 1
] through [
5
]
to begin the memory storage process, and the “ REC ”
icon will glow steadily.
6. Send the desired message using your keyer paddle.
A
DVICE
:
If you do not start keying within ten seconds, the
memory storage process will be cancelled.
7. 3 ress the [ MEM
] key on the
FH-2 once more at the
end of your message. Up to 0 characters may be
stored in each of the ¿ ve memories.
N
OTE
:
You must exercise care in sending to ensure that the
spaces between letters and words are accurately done
if
your timing is off, the spacing may not come out right
in the stored message. For ease in setting up the keyer
memories, we recommend you set
0 enu item “
018 F
KEYER TYPE
” and or “
020 R KEYER TYPE
” to “
ACS
”
$ utomatic Character Spacing) while you are program-
ming the keyer memories.