Yaesu FT DX 1200, Руководство по эксплуатации

Страница: 103 / 140

Page 101
FT
DX
1200 O
PERATING
M
ANUAL
M
EMORY
S
CAN
1. Set the transceiver up in the “ 0 emory” mode by
pressing the [ V/M
] button, if necessary.
. 5 otate the [ RF/SQL
] knob so that the background
noise is just silenced.
3. 3 ress and hold in the microphone [ UP
] or [
DWN
]
key for one second to start scanning in the speci ¿ ed
direction.
A
DVICE
:
ˆ If the scanner halts on an incoming signal, the
decimal point between the “ 0 H ] ” and “kH ] ”
digits of the fre T uency display will blink.
ˆ
If the incoming signal disappears, scanning will
resume in about ¿ ve seconds.
4. To cancel scanning, press the [ PTT
] witch.
A
DVICE
:
ˆ ' uring 0 emory Group operation, only the channels
within the current 0 emory Group will be scanned.
ˆ If the scan has paused on a signal, pressing the mi-
crophone [ UP
] or [
DWN
] key will cause scanning to
resume instantly.
ˆ
If you press the microphone PTT switch during
scanning, the scanner will halt at once. However,
pressing the
PTT switch during scanning will not
cause transmission.
ˆ
You may select the manner in which the scanner re-
sumes while it has paused on a signal, using 0 enu
item “
048 MIC SCAN RESUME
”. ' uring memory
scanning, the default “
TIME
” sec) setting will
cause the scanner to resume scanning after five
seconds. However, you may change this setting to
resume only after the carrier has dropped out, if you
like.
Q
UICK
P
OINT
:
If you have no interest in scanning, and wish to prohibit
the microphone [
UP
] [
DWN
] keys from initiating scan-
ning, you may disable scanning control from the mi-
crophone using
0 enu item “
047 MIC SCAN
” set it to
“
DISABLE
”).
VFO
AND
M
EMORY
S
CANNING
[V/M] Button
[RF/SQL] Knob