Page 114
FT-950 O
PERATING
M
ANUAL
MODE-SSB G
ROUP
064 J3E TX BPF
Function
: Selects the audio passband of the DSP modula-
tor on the SSB mode.
Available Values
: 1-30/1-29/2-28/3-27/4-26
Default Setting
: 3-27: 300 ~ 2700 (Hz)
1-30: 100 ~ 3000 (Hz)
1-29: 100 ~ 2900 (Hz)
2-28: 200 ~ 2800 (Hz)
3-27: 300 ~ 2700 (Hz)
4-26: 400 ~ 2600 (Hz)
N
OTE
:
The
apparent
power output, when using the widest band-
widths, may seem lower. This is normal, and it occurs be-
cause the available transmitter power is distributed over a
wider bandwidth. The greatest compression of power out-
put, conversely, occurs when using the “4-26” setting (400
~ 2600 Hz), and this setting is highly recommended for
contest or DX pile-up work.
065 J3E LSB CAR
Function
: Adjusts the receiver carrier point for the LSB
mode.
Available Values
: –200 Hz ~ +200 Hz (10 Hz steps)
Default Setting
: 0 Hz
066 J3E USB CAR
Function
: Adjusts the receiver carrier point for the USB
mode.
Available Values
: –200 Hz ~ +200 Hz (10 Hz steps)
Default Setting
: 0 Hz
RX GENERAL G
ROUP
067 RGEN NB 1 LVL
Function
: Adjusts the noise blanking level of the IF Noise
Blanker for short duration pulse noise.
Available Values
: 0 ~ 255
Default Setting
: 128
068 RGEN NB 2 LVL
Function
: Adjusts the noise blanking level of the IF Noise
Blanker for longer duration pulse noise.
Available Values
: 0 ~ 255
Default Setting
: 128
069 RGEN CNTR LV
Function
: Adjusts the parametric equalizer gain of the
Contour filter.
Available Values
: –40 ~ +20 dB
Default Setting
: –15 dB
070 RGEN CNTR WI
Function
: Adjusts the Q-factor of the Contour filter.
Available Values
: 1 ~ 11
Default Setting
: 10
071 RGEN DNF
Function
: Enables/disables the Digital Notch Filter.
Available Values
: OFF/On
Default Setting
: OFF
072 RGEN DNR
Function
: Set the Digital Noise Reduction response.
Available Values
: OFF/1 ~ 15
Default Setting
: OFF
M
ENU
M
ODE
IF
BANDWIDTH
“+” Gain
“Q”
“--” Gain
CONTOUR “G
AIN
”
AND
“Q”
