Yachting Electronic Co. NAKI8850B, Руководство пользователя

Страница: 28 / 59

2. Adjust the float so that it is 150 to 250 mm away from
the transducer.
3. Replace the rubber stopper. To prevent accidental loss
of the stopper, always press the rubber stopper firmly
into the float before tossing the transducer into the water.
Using the transducer Using the transducer
1. Toss the sensor and float assembly into the water. To
toss, place the sonar sensor and float in your hand, and
pitch underhand. Do not throw the sensor by the cable
as this will cause unrepairable damage. Before tossing,
be certain that the cable is free from tangles and is not
wrapped around anything.
2. Use a pole to guide the sonar sensor to a desirable
position or add floats on the cable to put the sensor at
the corresponding position.
3. To retrieve the sensor and float simply pull in the cable
being certain to neatly wind up the excess cable.
Note: Note: To remove the Sonar Sensor Float, remove the
rubber stopper first, then slide the cable through the center