Yacht Devices YDAB-01, Руководство пользователя

Страница: 30 / 38

— 30 —
Situation Possible cause and actions
No external LED indication
1. External LED is connected incorrectly.
See section III. 2. Pay
attention to LED polarity.
2. Wiring issue. Check LED wiring for a short or a bad contact.
3. LED failure.
Check LED with a tester.
External button does not
work at all
1. External button is connected incorrectly.
See section III. 2.
2. Wiring issue. Check button wiring for a short or a bad contact.
3. Button failure. Check button with a tester.
External button does not
work as expected
1. Wrong mode. Check current mode with an external button
(see Section IV) or the YD:MODE command (see Section V).
Digital switching mode:
Device does not work in sync
with NMEA 2000 digital
switching equipment in
digital switching mode
1. Wrong bank. Check that NMEA 2000 digital switching equipment
has the same bank. Reconfigure Device with YD:BANK command
(see Section V).
2. You are using Maretron NMEA 2000 digital switching
equipment but the Maretron support is not enabled.
Enable Maretron support with YD:MARETRON ON command
(see Section V).
3. You are using CZone NMEA 2000 digital switching equipment
but the CZone support not enabled.
Enable CZone support
with YD:CZONE ON command (see Section V).
Engine alarm mode:
Device does not get engine
data, built-in LED flashes
red every 2 seconds
1. No engine data in NMEA 2000 network. Check that engine data
is available on a NMEA 2000 network.
2. Wrong engine instance setting. Check and modify monitored
engine instance setting with YD:ENGINE command (see Section V).
Table continued