12
11
1
2
3
Do not apply flash on the same area more than once a day.
The results vary from person to person and depend on which body area is treated.
If you are not satisfied with the results, continue to treat every 2 weeks for more
than 2 months until you see the desired results.
This device is not designed for permanent hair removal.
If regular treatment is discontinued, it may be difficult to see results and you may
find that unwanted hair will gradually grow back.
Do not use more often than the recommended frequency of
treatment above.
If you wish to treat the area more than the recommended treatment
frequency, always check your skin condition before and during use.
Do not apply flash on the same area more than once per day as this
may cause skin irritation or damage.
CAUTION
Treatment
Frequency of Treatment
Treatment Steps
< Body Care >
Shave
→
Apply flash treatment
→
Cool down the treatment area using Cool mode
NOTE: If unwanted hair is longer than 1mm, always shave first before
performing flash treatment.
During first 2 months
Every 2 weeks
Once in 4-8 weeks
After 2 months of treatment
①
②
③
< Face Care >
Attach Face Attachment and then perform flash treatment
→
Remove Face Attachment
→
Cool down the treatment area using Cool mode
NOTE: Shave long unwanted hair, unwanted dark hair, and hair
around the mouth before performing flash treatment.
①
②
③
Test the Flash on a patch of skin
Set the Flash Level
Set to a level at which you feel a mild sensation of warmth
or heat. Do not use at a level that is intolerable.
Adjust the Flash level according to the treatment area.
Do not set the flash level high for those with dark skin tone or
recently tanned skin. Doing so may cause skin irritation.
Press and hold Power / Cool button for approx. 3 seconds
to turn on the power.
Body:
No attachment needed.
Face:
Use the Face attachment.
* When using the Face attachment, attach it to the treatment
head after turning on the power.
Test the flash on a patch of skin near the area you plan to
treat starting at Level 1.
See section “How to Use Flash Mode” on p.13.
Wait 24 hours and then examine the treatment area.
If the skin appears normal (skin condition without any redness,
blisters, or burns), then start your first treatment.
Please follow these instructions prior to your first treatment.
Before Use
Treatment
