10
9
1
2
Shave the treatment area with your own shaver.
Unwanted hair or debris on the skin surface may cause burns.
Do not pluck or wax unwanted hair on areas you wish to treat.
Make sure the attachment and treatment window are clean,
free of dirt and debris, undamaged, and in good condition.
Always clean the treatment window if it is dirty to prevent malfunction,
deterioration, burns, injury, and skin irritation.
Refer to the section “How to Clean” (p.19) for details on cleaning.
Preparing for Treatment
Follow these instructions before every treatment for best results.
Operation Panel
Set the treatment intensity.
There are 5 adjustable levels.
With each press of a Level button, the corresponding Level lamp will turn
solid green. At maximum, all 5 Level lamps will be lit.
The higher the level, the more warmth you may feel when using Flash.
Be sure to start from Level 1 until you get used to treatment.
Level UP and Level DOWN Buttons
Lamp off:
The unit is in standby (waiting), or the treatment window is not
entirely covering the treatment area.
Solid green:
Treatment window is properly touching the skin and pressing
the Emission button will emit flash.
You will hear two short beep tones when the unit is ready for treatment.
Standby Lamp
Power / Cool Button
ON: Press and hold
(approx. 3 sec.) to turn ON
(Level 1 lamp will be solid green)
COOL: Press
(approx. 1 sec.) to switch to Cool Mode
(Mode Lamp is solid blue)
OFF: Press
(approx. 3 sec.) to turn OFF
(Lamps are off)
The fan will run for about 90 seconds after power is turned off.
Do not unplug the AC adapter until the fan stops running.
Level
Indicator
Lamp
Level Up
Button
Level Down
Button
Standby
Lamp
Mode Lamp
Power / Cool Button
Emission
Button
Before Use
Before Use
Before Use
