13
14
Ho
w to Use
Ho
w to Use
How to attach cotton to the electrode head
1
Remove the cotton stopper from
the electrode head.
2
Place a piece of cotton on top of the electrode head
and press the cotton stopper down over the cotton.
* If the cotton stopper does not fit properly on the electrode head, please use a larger and thinner
piece of cotton. Because thick cotton pads are difficult to fix in place, split them in half before use.
* If the cotton is too thick, the thermal action of RF treatment may be adversely affected and you will
feel less heat.
3
Apply your regular skin lotion or gel onto the cotton.
* Make sure the skin lotion or gel coats the entire surface of the electrode head.
* If using a waterly (low-viscosity) skin lotion, the feeling of warmth may decrease.
Recommended skin lotions: RF Booster Pad (page 21) or high-viscosity skin lotions.
* If the cotton pad becomes dry, add more skin-care product. Cotton pads may easily come off
from the device when they are dry.
How to Use
1
Remove makeup and gently cleanse your face.
• Remove oil and dirt from your skin so that it is in a clean condition prior to treatment.
* COOL Mode can be used over makeup.
3
Connect the AC adapter to turn the power on.
Press the mode button and select a mode and intensity level.
• First, press and hold the button of the mode you wish to use to start. Then press the button again
briefly to select the level.
• Start using the device in EYE Mode only after rotating the electrode head.
* The intensity level cannot be selected for COOL Mode.
* Always select Level 1 upon the first use until you are accustomed to use.
2
Attach cotton if necessary and apply skin lotion onto the cotton.
Treatment Method
4
When holding the device, make sure that you are touching the hand
electrode (silver rim) on the rear of the device.
6
Unplug the AC adapter from the main unit and the wall socket to
turn the power off.
After treatment, condition your skin as necessary.
• Please apply skin cream as appropriate.
* Clean the main unit after each use (page 17).
7
5
Gently apply the treatment head to your skin and move the head
over the area being treated. Refer to pages 15-16 for more details.
• When operation in each mode is completed, the device will switch to Standby Mode. To start the next
mode, press and hold the relevant mode button.
* During use, make sure the electrode head is closely touching the skin.
* If you wish to stop the mode you are using half-way through the operation, press and hold the relevant
mode button.
How to Use (General Instructions)
Precautions
Be sure to move the device on your skin while using it. Using the device continuously on the same area
may cause burns or other injuries (except when using the device in EYE Mode or COOL Mode).
The warmth of the RF changes depending on the type of skin-care product used and the skin’s
condition at the time of treatment.
Do not use this device around the eyes unless it is in EYE Mode or COOL Mode.
* The LED light can be used around the eyes and eyelids. Close your eyes and hold the device at least
5 cm away from the skin.
Do not look directly into the LED light.
When holding the device, make sure that you are holding the hand electrode.
The recommended ambient temperature is 15° C to 30°C.
