11
12
2
Apply skin-care product (gel or lotion) or water on your arm.
Use the device for approximately 3 minutes in MOIST Mode.
• Do not wet or rub the pre-testing area.
There are five levels for CLEAN and MOIST Modes, and three levels for EYE Mode.
Each time the CLEAN or MOIST button is pressed, the level switches as shown in the below picture.
* There is no level selection available for COOL Mode.
* Use only Level 1 upon the first use and until you are accustomed to use.
Level Indicator
One short beep will sound to indicate the half-way point in the operation time.
Refer to pages 9 -10 for operation times in each mode.
Pre-testing on Skin
Level 1
Level 2
Level 3
Level 4
Level 5
* When using the device or a cosmetic product for the first time, always test for compatibility.
1
Clean your skin.
• Wash the inside of your wrist with soap, then wiping it dry with a towel.
If you experience any skin abnormality (redness or burning sensation) at the pre-testing
area within 24 hours, stop using the device.
ATTENTION
• Be sure to perform a pre-test in order to prevent skin problems from occurring.
• If a rash, reddening, itchiness, stinging sensation or other abnormalities occur at the
pre-testing area, immediately stop the pre-test and wash the area.
• Check carefully to make sure there is no skin abnormality before using the device.
Stop using the device immediately if the treatment does not agree with your skin.
Timer
• This mode cares for the skin around the eyes using two electrodes on the electrode head.
• Rotate the electrode head 180° to switch between EYE Mode and Standby Mode.
The electrode head only rotates in the direction of the arrow shown in the figure on the right.
• The device cannot be operated in Eye Mode if the electrode head is not rotated 180°.
In addition, the device cannot be used in other modes while the electrode head
is rotated.
How to Use EYE Mode
When treatment on a certain mode is completed, two short beeps sound and the device switches to Standby
Mode (the state in which functioning is suspended). Refer to pages 9 -10 for operation times in each mode.
Press and hold the mode button again to start the selected mode.
Standby Mode
EYE Mode electrode
* Rotates only as far
as 180°.
CLEAN and MOIST Mode
EYE Mode
Befor
e Use
Befor
e Use
