15
16
How to Apply the Device on Your Skin
<Clean and Moisture Mode>
・ If the temperature feels too hot, move the head little quicker. You can
also use cotton to prevent the heat.
・ Use in a position in which the entire surface of the electrode head
comes into contact with your skin.
・ Be sure to move the device on your skin during use.
Using the device continuously on the same area may lead to burns
and low temperature burns.
・ Do not put the electrode head on the eyelids or around the eyes.
<COOL Mode>
Press the electrode head repeatedly
on your face as if stamping on the
skin (Press→Release→Move the
electrode head).
* You can use the device on the
eyelids or areas around the eyes.
Areas you should not treat.
Areas that can only be treated
with LED light in Moisture
mode (page 16).
* Close your eyes and hold the
electrode head 5 cm or more
away from the skin.
Move the electrode head over the skin in the direction of the arrows shown below.
Recommended speed for moving the
device: 2cm/second
Press and move the device in a
circular, massaging motion as
indicated by the arrows.
Areas that can only be treated
with LED light.
(See below about how to use.)
* Close your eyes and hold the
electrode head 5 cm or more
away from the skin.
●How to treat areas around the eyes and the eyelids using
the LED light in Moisture, EMS Up, or Cool mode.
Remove RF booster pad or cotton, close your eyes, and irradiate with
the electrode head at a distance of 5 cm or more from the skin.
An area you should not treat:
Upper eyelid
<Eye Care Mode>
Repeat the action of ʻpressing and removingʼ from the inner corner to
the outer corner of the eye just like pressing a stamp.
* Do not keep pressing for over 3 seconds.
* Do not move the device while pressing.
* Areas around the eyes (under
eyelid, outer corner of the eye)
can be treated
Pressing time: About 3 seconds for
one spot
Right
side
Approx.
90 seconds
Beep
Standby
display
Approx.
3 minutes
Three short
beeps
Left
side
Approx.
90 seconds
Right
side
Approx.
1 minutes
Beep
Standby
display
Approx.
2 minutes
Three short
beeps
Left
side
Approx.
1 minutes
Right
side
Approx.
90 seconds
Beep
Standby
display
Approx.
3 minutes
Three short
beeps
Left
side
Approx.
90 seconds
Right
side
Approx.
90 seconds
Beep
Power off
Approx.
3 minutes
Two short
beeps
Left
side
Approx.
90 seconds
How to Use
How to Use
It is recommended to apply the device
on one side of your face for 2 minutes,
a total of 4 minutes on both sides, for
those who are concerned about the
dry skin around the eyes.