13
14
How to Use
How to Use
Attaching Cotton to the Head
1
Remove the cotton stopper
from the electrode head.
2
Place a piece of cotton on top of the
electrode head and press the cotton
stopper down over the cotton.
* If the cotton stopper does not fit properly on the electrode head, please use a
larger and thinner cotton. Thick cotton may not fit well, so it should be torn in
half.
* If the cotton is too thick, the thermal action of the RF treatment may be
adversely affected and you will feel less heat.
3
Apply your regular skin lotion or gel onto the
cotton.
* Make sure the lotion or gel coats the entire surface of the electrode head.
* If using a smooth (low-viscosity) skin lotion, the feeling of warmth may
decrease.
Recommended skin lotions: RF Booster Pad and high-viscosity skin lotions
* After use, make sure to remove lotion or gel on the electrode head or rinse
it lightly. Do not put the device into the water.
How to Use
1
Remove makeup and gently cleanse your face.
・ Remove oil and dirt from your skin so that it is in a clean
condition prior to treatment.
* Cool mode can be used over makeup.
3
Press and hold the Power/Mode button for
approx. 3 seconds to turn on the power. Select
the mode and intensity level.
・ Select the mode using the Power/Mode button.
・ Select the intensity level using the Level button.
* The intensity level cannot be selected for RF, Micro Current, LED,
and Cool mode.
* Always select Level 1 upon the first use and until you are
accustomed to use.
2
Attach cotton if necessary and apply lotion onto
the cotton.
●How to Apply Treatment
4
When holding the device, make sure that you are
touching the hand electrode (silver rim) on the
rear of the device.
6
Press and hold the Power/Mode button for
approx. 3 seconds to turn off the power.
After treatment, condition your skin as necessary.
・ Please apply skin cream as appropriate.
* Clean the device after every treatment (page 17).
7
5
Gently apply the electrode head to your skin and
move the head over the area being treated. Refer
to pages 15-16 for more details.
・ When the treatment in each mode is finished, the device will go
into standby status for approx. 2 minutes. Press the Power/Mode
button to start the next mode. After using the Cool mode, the
device will automatically turn off.
* During use, make sure that the electrode head is firmly touching
the skin.
* After using the Cool mode, the device will automatically turn off.
* Hold the device with your fingers without touching the charging
terminal.
You may feel irritation.
How to Use (General Instructions)
●Precautions
●Be sure to move the device on your skin during use. Using the device
continuously on the same area may cause burns or other injuries.
●When using RF, you may feel the temperature difference depending on the
type of cosmetics you wear or skin condition.
●Do not use this device on eyelids or around the eyes (except using in Eye
Care and Cool mode).
* The LED light can be irradiated on the eyelids and around the eyes. Close
your eyes and hold the electrode head 5 cm or more away from the skin.
●Do not look directly into the LED light.
●When holding the device, make sure that you are touching the hand electrode.
●Recommended ambient temperature is 15°C to 30°C.
