10
9
Before Use
Before Use
The charging indicator will flash while
the device is charging.
When charging is complete, the
charging indicator will turn solid.
* Not shown during use
●Charging Indicator
When Clean, Eye Care, Moisture, and EMS Up modes finish (3 minutes for
each mode), the indication of the next mode blinks and the device will be
on standby status* (not in operation).
* When you press the Power/Mode button, the next mode that is waiting
in Standby status will start.
* If the next mode does not start within approx. 2 minutes, the device will
emit two short beeps and the power will turn off automatically (Auto-off).
When treatment in Cool mode has finished, the power will turn off
automatically (Auto-off) without the device going to Standby status
(the device emits two short beeps and the power switches off).
●Standby and Auto-off (Automatic Power Off)
Select CLEAN Mode and press LEVEL button, and you can choose an
ion level.
Select MOISTURE Mode and press LEVEL button, and you can choose
the level of DYHP.
Select EMS UP Mode and press LEVEL button, and you can choose the
level of EMS.
Please select the intensity level which you feel the most comfortable
from 5 levels.
Every time you press LEVEL button, the level changes from Level 1→
Level 2→ Level 3→ Level 4→ Level 5→ and Level 1again …(repeat).
* The intensity level cannot be selected for RF, Micro-current, LED, and
Cool mode. Use only Level 1 upon the first use and until you are
accustomed to use.
●Level Indicator
Level 1
Level 2
Level 3
Level 4
Level 5
(Flashing)
<Charging>
<Fully charged>
(Solid light)
Each time you press the Power/Mode button, the treatment mode will be
selected in the following order: Clean→Eye Care→Moisture→EMS Up→
Cool→Clean (repeat).
●Mode Indicator
CLEAN
RF /
Ion Cleansing
* When using the device in Clean or Moisture mode, the RF mode
indicator repeatedly blinks on and off.
RF /
Micro-current
RF /DYHP
LED (red and orange)
Cool /
LED (blue)
EYE CARE
MOISTURE
EMS /
LED (red)
EMS UP
COOL
○
Mode
Function
Mode Indicator
Pre-testing on the Skin
* When using the device or a cosmetic product for the first time, always
test for compatibility with the skin.
1
Clean your skin.
・ Wash the inner arm with a soap and water and wipe dry with a towel.
2
Apply cosmetics (gel or lotion) or water to your inner arm
and use the device for approx. 3 minutes in Moisture mode.
・ Do not wet or rub the pre-testing area.
If you experience any skin abnormality (redness or a burning sensation)
on the pre-testing area within 24 hours, discontinue use of the device.
ATTENTION
・ Make sure to perform a pre-test in order to prevent skin
problems from occurring.
・ If a rash, reddening, itch, stinging sensation, or other
abnormality occurs on the pre-testing area, immediately
stop the pre-test and wash the pre-testing area.
・ Do not use the device if your skin shows any abnormality.
You will hear a beep after the first half of the treatment time with the
selected mode.
When you hear a beep, use the device on the other side of your face.
●Notice Timer Alarm Function
