34
Operations
03
6.
Locate the Bolide software pack and navigate to the following folder:
Bolide_Y-01_Arduino_Support_File_20151201\Bolide_Y-01_UserMotion
(For the latest
software visit http://www.xyzrobot.com)
7.
In the same folder, locate and open
RCK100_6DOF_Wheel.ino
file.
8.
Three main tabs display. Click the
OTHERS_USER_MOTION.h
tab.
9.
In the file body, locate the line section named
//===== User Define Pose ======
or
//===== User Define Sequence ======
.
10.
Paste the previously copied Pose and Sequence information under the User Motion line. See the
following example.
//===== User Define Pose ======
const PROGMEM unit16_t U_p1[] = {6, 622, 251, 504, 602, 400, 625};
const PROGMEM unit16_t U_p2[] = {6, 400, 350, 400, 200, 850, 750};
//===== User Define Sequence ======
const PROGMEM transition_t U_s1[] = {{0,2}, {p1,500}, {p2,1000}};
11.
Click
File > Save
to save the file with the new section.
The file is now ready for the configuration process, see
“Programming the Control Panel”
on
page 35
or
“Programming the Remote Control”
on page 36
.
12.
Under the section
=== User Sequence Setup ===
, select an entry. In the following
example, the entry selection is
#define ActionNo_1 None
.
13.
Under the column None, enter a name to personalize the entry. In the following example the
selection is renamed U_s1; the name set here matches the name set defined in Step 12.
////==== User Sequence Setup ====////
#define ActionNo_1 U_s1
#define ActionNo_2 None
#define ActionNo_3 None
#define ActionNo_4 None
#define ActionNo_5 None
14.
Save the file once you’ve completed the modifications. The
OTHERS_USER_MOTION.h
file is
ready for use in further programming.