Xyron XRN4400, Инструкция по эксплуатации

Страница: 22 / 26

21
Machine Troubleshooting (Continued)
SYMPTOM POSSIBLE PROBLEM TEST/ACTION
Film does not lay flat, curls
and / or wrinkles.
Initial loading of film without
advancement through machine
until advancement could cause
adhesive buildup on lower idler
bar.
Tension on film may cause
wrinkles and is not a film quality
issue.
Clean adhesive buildup from idler
roller using isopropyl alcohol.
Check end hub tension and
make sure the material is
stress free.
The machine will not run. Loss of power or mechanical
stop has been released. The power plug is pressed
completely into its socket and
there is power to the socket.
The "Power" button is on.
The green light should be on.
The emergency stop has been
released.
The control mode (foot/auto) is
correct.
The fuse located in the rear of
the machine is not blown.
Static Sparks It is not uncommon for a
small static spark to jump
between two metal parts
while the machine is running.
This is static electricity,
caused by friction between
the plastic film and the
machine, and is not a cause
for concern. This
phenomenon can be seen
more often in dry and warm
climates. If this is occurring
you may also on
rare occasions receive a tiny
shock, the same as touching
metal after walking over
some carpets. This effect will be fairly minor.
If you feel something is wrong
with the machine electrically,
please cease using the
machine and contact
Xyron at 1 800 793-3523.