Xyron XRN4400, Инструкция по эксплуатации

Страница: 16 / 26

15
Loading Film (Continued)
Step 3:
•
Make certain the lower film is tight. If necessary, rotate the
supply roll backwards to tighten.
•
Grasp the film from the upper supply roll, and adhere it to
the exposed adhesive on the lower supply roll. For best
results, adhere the top film 1 inch below the round steel
idler bar. By carefully aligning the edges, keeping the film
tight and avoiding wrinkles, film waste will be minimized.
Step 4:
•
Use the foot pedal to run the film through the machine.
•
Ensure that the film is exiting under the cutter bar
assembly.
•
Run material through the machine until all wrinkles go
away.
•
Material amount will vary depending on loading accuracy.
•
Expect to run approximately 3 to 4 feet through the system.
•
Trim off excess film by using the hand held cutter and
sliding it in either direction.
Step 5:
•
Install feed tray completely by aligning the support posts in
the grooves located in the sides of the machine.
First, insert right side of tray Second, insert the left side of tray
You are now ready to feed your documents!
Guide film out the back of the machine
Tacking laminate from top roll to exposed
adhesive on bottom roll