Xylem GOULDS e-AB Series, Инструкция по эксплуатации

Страница: 33 / 56

Mark Parameter type
G
Global parameter, shared by all pumps in the same multi-pump system
Read only
6.6.1 Status parameters
Parameter
number
Parameter name Unit of measurement Description
P01 Required value bar/psi/ rpmx10 This parameter shows the SOURCE and the
VALUE of the active required value.
Visualization cycles between SOURCE and
VALUE occur every 3 seconds.
SOURCES:
• SP (SP): internal required value Setpoint
related to the control mode selected.
• VL (UL): external required value speed
Setpoint related to 0-10V input.
VALUE can represent a Speed or a Head,
depending on the selected control mode:
in case of Head, the unit of measure is
defined by parameter P41.
P02 Effective Required
Value
bar/psi Active required value calculated based on
parameters P58 and P59.
This parameter is effective only in control
modes MSE or MSY.
For further information on the calculation of
P02, see Par. 6.6.3.
P03 Regulation Restart
Value [0-100]
G
% It defines the start value after the stop of the
pump, as a percentage of the P01 value. If
the required value is met and there is no
further consumption, then the pump stops.
The pump starts again when the pressure
drops below P03.
P03 is valid when:
• Different from 100% (100%=off)
• The control mode is HCS, MSE or MSY.
Default: 100%.
P04 Auto-start [OFF-
ON]
G
If P04 = ON, then the pump starts
automatically following a power supply
disconnection.
If the pump is switched on after setting P04 =
OFF (see Par. 6.5.1), it is stopped so that the
motor is not in operation, and STP flashes
(STP → STP).
Default: ON.
P05 Operating time
months
Total months of connection to the electric
mains, to add to P06.
6 System Setup and Operation
Smart Pump Range INSTRUCTION MANUAL 31