Xylem GOULDS e-AB Series, Инструкция по эксплуатации

Страница: 31 / 56

Display Mode Description
ON ON Pump on; the motor starts following the selected control mode.
It appears for a few seconds when contacts 11 and 12 (see Par. 5.4)
are short circuited and the pump is not in STOP mode.
To manually set the pump to ON mode:
• Example A:
– HCS, MES, MSY control modes that reach a required value (head)
of 4.20 bar, starting with a minimum value of 0.5 bar after manual
stop: STP →
press → ON → once after a few seconds… → 4.20
BAR.
• Example B:
– ACT control mode that reaches a requested value (speed) of 200
10xRPM, starting with a minimum value of 80 10xRPM after
manual stop: STP →
press → ON → once, and after a few
seconds… → 200 10xRPM.
With the pump in operation, it is possible to display the Actual Head and
the Actual Speed:
• Example A:
– HCS, MES, MSY control modes with Actual Head 4.20 bar and
corresponding Actual Speed of 352 10xRPM: 4.20 BAR → +
→ 352 10XRPM → after 10 seconds or + → 4.20 BAR.
• Example B:
– ACT control mode with Actual Speed 200 10xRPM and
corresponding Actual Head of 2.37 bar: 200 10xRPM→ + →
2.37 BAR→ after 10 seconds or + → 200 10xRPM.
sby Stand-by The analog input is configured as speed set (P40 = ISP or USP), the
read value is in the Stand-by zone and P34 = STP (see paragraph
6.6.1)
Note: It has lower display priority that STOP mode
-0– Lock
To lock press + for 3 seconds; the lock will be confirmed by the
temporary appearance of
-0–
It appears is a button is pressed (with the exception of
) after a
locking procedure had been completed.
Note: the function connected with START/STOP
is always disabled.
At startup the buttons are locked, if they were locked at the previous
switch off
Default: unlocked
() Unblock
To unlock press + for three seconds; the unlock will be
confirmed by the temporary appearance of
()
Note: At startup the buttons are unlocked. if they were unlocked at the
previous switch off
Default: unlocked
6.5.2 Parameters menu visualization
The parameter menu gives the possibility to:
• select all the parameters (see Par. 6.5)
• access Parameter View / Editing (see Par. 6.2).
6 System Setup and Operation
Smart Pump Range INSTRUCTION MANUAL 29