5015SLR Flat Panel Industrial Touch Monitor Chapter 2 – Installation
10
144812(D)
Figure 2-8. Stainless Steel Mounting Clip Locations
Mounting into a 5015SLR Opening
The 5015SLR has 14 total mounting clips: 4 on both the top and bottom of the monitor, and 3
mounting clips on both of the sides. Hold the monitor in place while you install the mounting clips
(see Figure 2-7 or Figure 2-8 for mounting clip locations). Tighten the clips in a crisscross pattern.
This will help to develop an even pressure on the sealing gasket. Tighten the clips until the back of
the monitor's front bezel begins to contact the front of the NEMA enclosure (at least 7 in-lbs of
torque).
Insert the hook section into the slots and tighten the fastener with a screwdriver, as shown. Tighten
the clips until the back of the monitor’s front bezel begins to contact the front of the NEMA enclosure
(at least 7 in-lbs of torque).
