SEQUENCE/ SCAN/ PATROL
No. Pre Spd Time
01 n1 n2 n3
No.: index of the points, max. 16
Pre.: Preset-position assigned for this point, from 1 to 255
Spd: The cruising speed to this point, 1 (lowest ) to 8 (highest speed)
Time: duration of the stay in seconds (1 to 99)
The cursor now is pointed to n1 ( preset), Use [[Enter] to assign a preset to this point. The
number can be from 1 to 255. After assigning, the cursor will move automatically to n2 (speed). Use
[FAR] or [NEAR] to move the cursor from 1 parameter to another. For moving to next point, please
press [TELE] or [WIDE].
After the setting for all points is done, you need to press [SEQ] ( less than 3 sec) to save the sequence
and turn back to the main menu:
No. Pre Spd Time
Save, waiting.......
If any point of a sequence has been assigned with 0 ( means no preset),
then all the points after this one will be set to 0.( deleting)
Activate a stored sequence:
[SEQ] + [N]+ [ENTER]
SEQ n
[N] can be any number between 1 to 4, please note not to press
[SEQ] longer than 3 sec.
LCD will show the calling of sequence no. N has been executed.
Scan
Activate Scan:
[SCAN] + n + [ENTER]
SCAN n
LCD shows the activation of scan
In order to work with the Scan-Function, you might need to
enter the device‘s setup-menu and define the scan-points
Patrol
Set Patrol:
Press the key [PATROL] for long than 3 sec. for entering the patrol setup mode, then
press patrol number ( 1 to 4) setup. Use [ENTER] for confirmation.
[PATROL] ( 3 sec.) + n + [ENTER]
SET Patrol n
Note: You can only setup the patrol-function on device
which support this feature.
Activate a patrol-track:
[PATROL] + n + [ENTER]
Patrol n
12
Note: which is to call learning (pattern scan), the actual command
code is Call + (70 + n) + Enter , n means Learning No.
Note: which is to call SEQ(track), the actual command code is
(70 + n) + Enter , n means Track No.
※
n + Enter and SEQ + n + Enter are effective to XTS
，
XTS2
，
PelcoD and PelcoP protocol.
※
n + Enter and SEQ + n + Enter are only quick calls of learning (pattern scan) and SEQ;
XTS-2 CAM:001
XTS-2 CAM:001
XTS-2 CAM:001
XTS-2 CAM:001
the corresponding setting must be done by the dome camera and PTZ menu.
