www.XtremeAirUsa.com
Page 14
MAINTENANCE:
SAFETY WARNING: Never put your hand into area housing the fan while the fan is operating!
For optimal operation, clean range hood and all baffle/spacer/filter/grease tunnel/oil container regularly.
Regular care will help preserve the appearance of the range hood.
Cleaning Exterior surfaces:
•
Clean periodically with hot soapy water and clean cotton cloth.
Do not use corrosive or abrasive
detergent (e.g. Comet Power Scrub
®
, EZ-Off® oven cleaner), or steel wool/scoring pads, which
will scratch and damage the stainless steel surface.
For heavier soil use liquid degrease such as
“Formula 409
®
” or “Fantastic
®
” brand cleaner.
•
If hood looks splotchy (stainless steel hood), use a stainless steel cleaner to clean the surface of the
hood. Avoid getting cleaning solution onto or into the control panel. Follow directions of the stainless
steel cleaner.
CAUTION:
Do not leave on too long as this may cause damage to hood finish. Use soft
towel to wipe off the cleaning solution, gently rub off any stubborn spots. Use dry soft towel to dry the
hood.
•
After cleaning, you may use non abrasive stainless steel polish such as 3M ® or ZEP®, to polish and
buff out the stainless luster and grain. Always scrub lightly, with clean cotton cloth, and with the grain.
•
DO NOT
allow deposits to accumulate or remain on the hood.
•
DO NOT
use ordinary steel wool or steel brushes. Small bits of steel may adhere to the surface and
cause rusting.
•
DO NOT
allow salt solutions, disinfectants, bleaches, or cleaning compounds to remain in contact with
stainless steel • for extended periods. Many of these compounds contain chemicals, which may be
harmful. Rinse with water after exposure and wipe dry with a clean cloth.
Cleaning Aluminum Grease Filter / Stainless Steel Filter less Grill:
IMPORTANT:
Drain oil from oil containers before oil and residue overflow!
•
The metal filters fitted by the factory are intended to filter out residue and grease from cooking. It need
not be replaced on a regular basis but are required to be kept clean.
•
Filters should be cleaned after every 30 hours of use.
•
Remove and clean by hand or dishwasher. Spray “Formula 409®” or equivalent degreasing detergent
and leave to soak if heavily soiled. Dry filters and re-install before using hood.
Replacing Filters:
•
Should filters wear out due to age and prolonged use, please contact your local reseller for replacement
filters.
Note: Also replace damaged filter that has punctured or broken mesh, bent or broken frame.
Replacing the light bulb:
•
This range hood uses LED 2w bulb (please refer to the actual specification of the hood purchased): •
USA/Canada: LED 2 WATTS
Make sure the range hood is unplugged or turn OFF breaker.
Make sure the lights are cool to touch, carefully align the arrow on the inner ring with the arrow on the outer
ring where says OPEN. The inner ring will loosen and the light bulb will be available for removal. Install a
new halogen light bulb and reverse the steps.
Turn ON breaker and range hood to test for operation.
