Installation Guide
P. 7
9
PURPLE
(-) External
Trigger
The External Trigger wire can be used for remote-starting the vehicle
with an external device. When the vehicle is running, triggering this
input will activate Idle Mode. The External Trigger wire can also be used
to operate as a negative trigger with the Trunk Pin-switch, the Key
Sense wire or the Door Pin-switch:
Option 1
Connects to Negative Trunk Pin.
When this wire is
programmed for
TRUNK PIN
, pressing
TRUNK
will activate a 1-second
DISARM
output. If ground (-) is detected on the
TRUNK PIN
(the Trunk has
been opened), an
ARM
pulse will be sent 5 seconds after the Trunk is
closes. An
ARM
pulse will be sent 4 seconds after the
TRUNK
button is
pressed if the Trunk pin state is unchanged (The Trunk was unopened).
DISARM
is sent only if the system was previously locked and armed.
If
Secure Lock is enabled,
UNLOCK
pulse(s) will be sent with
DISARM, a
LOCK
pulse and a
REARM
pulse will be sent when the Trunk is closed
or if the Trunk was left closed.
Option 2 (Default: Engine Start/Stop):
The first Ground (-) pulse on
this input will start the Engine, the second Ground (-) pulse on this input
will stop the Engine.
Option 3 (Key Sense (-) Input):
Connects to OEM Key Sense Wire.
When the Key is detected in the Ignition Switch (Ground (-) signal on the
OEM Key Sense Wire) the Starter Kill will not
ARM
even when it is set to
Passive Mode. If Secure Lock is programmed,
LOCK
and
ARM
will not be
activated while the Key Sense input is active (“active” meaning there is a
key in the Ignition barrel).
Option 4 (Smart Ignition Re-Lock):
Connects to the Negative Door
trigger Input.
When the Ignition Lock Option or the Lock Only Option is
enabled: after the Brake Pedal is pressed and after a Door has been
opened and closed, the Doors will
RE-LOCK
.
10
WHITE
(–) Ground
out when
running
This is a 500-mA constant ground output active when the vehicle is
running under a remote start. The output becomes active 1-second
before the Ignition and becomes inactive when the Module shuts down
(i.e.: runtime has expired or the
START/STOP
button is pressed, etc.). The
output can be used to activate external relays, bypass kits, etc.
CAUTION!
If multiple relays or modules are connected to the Ground
Out wire, ensure that they are all diode isolated in order to avoid
feedback and damaging the vehicle.
11
GREY
N/A
Leave this pin empty.
