Xtreme Power 212 CC, Инструкция по эксплуатации и правила безопасности

Страница: 9 / 24

8
Be sure to read all information in the Safety and Operation sections before attempting to operate this
unit. Become familiar with all of the controls and how to stop the unit. Check all hardware (bolts, screws,
etc) before every use for tightness to be sure machine is in safe working condition. Upon start-up and
shut-down, you may hear the metal-to-metal sound of the triangular hammers and J-hammers positioning
themselves on the rotor. This is normal. If this sound continues after the machine has reached full speed,
contact your dealer or XtremePowerUS for an inspection of the unit. Overloading the equipment will shorten
its life, and can cause mechanical failures
The chipper is designed to handle tree limbs and branches up to approximately 3” (7,6 cm) in diameter. The
chipping knives also permit the processing of course organic matter like corn stalks. Tree branches must
be inserted large-end first into the chipper cone. Since occasional kick-backs may occur, always
stand off to the side of the unit. Allow the self-feeding action of the unit to draw the sticks in.
CHIPPER OPERATION
The shredder is designed to shred light brush, leaves, and other soft but bulky organic waste. As material
(no larger than 1/2 inch in diameter) is loaded into the shredder hopper it is pulled into the path of the
triangular and J-hammers by air flow.
SHREDDER OPERATION
Select an area with firm, level ground, covered by dirt or grass. Do not operate on wet or slick surfaces, or
near bystanders. Locate and organize the materials to be processed so that you don’t have to walk in front
of the inlet or discharge openings, and so you have adequate room to work safely.
OPERATING LOCATION
Refer to engine manual for information on adding oil.
ADDING OIL
TO AVOID SERIOUS PERSONAL INJURY FROM ROTATING CUTTING BLADES, KEEP
HANDS OUT OF INLET WHILE MACHINE IS RUNNING.
GASOLINE IS HIGHLY FLAMMABLE AND MUST BE HANDLED WITH CARE. NEV-
ER FILL THE TANK WHEN THE ENGINE IS STILL HOT FROM RECENT OPERATION.
DO NOT ALLOW OPEN FLAME, SMOKING OR MATCHES IN THE AREA. AVOID
OVER-FILLING AND WIPE UP ANY SPILLS.
DO NOT USE GASOLINE CONTAINING METHANOL, GASOHOL CONTAINING MORE
THAN 10% ETHANOL, GASOLINE ADDITIVES OR WHITE GAS BECAUSE ENGINE/
FUEL SYSTEM DAMAGE COULD RESULT.
ENGINE IS SHIPPED FROM FACTORY WITHOUT OIL. YOU MUST ADD ENGINE OIL
BEFORE STARTING ENGINE.
1. Remove the fuel cap. (SEE FEATURES AND CONTROLS)
2. Fill the tank. Do not overfill. Leave room in the tank for fuel expansion. Refer to your engine manual
for specific fuel recommendations.
3.
Install and hand tighten the fuel cap.
ADDING FUEL
OPERATION