Xtreme Power 212 CC, Инструкция по эксплуатации и правила безопасности

Страница: 8 / 24

1.
Hold the hopper guard assembly (A) so that the rubber guard is
directed down towards the bottom of the hopper. Align the assembly
holes with the holes in the hopper.
INSTALL THE HOPPER GAURD
2.
Using the three M6-1.0 x 16 bolts (B), M6 springlock washers (C)
and M6-1.0 nuts (D), secure the guard assembly (A) to the hopper.
Insert the bolts with washers from the outside of the shredder
hopper.
1. Hold the hopper handle (A) up so that the outer holes in the
handle align with the holes in the hopper and secure with four M8-
1.25 x 20 bolts (B), M8 washers (C) and M8-1.25 nuts (D). Insert
the screws from the outside of the hopper.
INSTALL THE HANDLE
1.
Slide the support rod (A) into the bracket (B). SEE FIGURE 8. Rotate the rod so that it sits below the
front tab (C) of the bracket. FIGURE 9
INSTALL THE DEBRIS BAG
2. Slide the tabs (D) on the debris bag onto the support rod. FIGURE 10
3. Secure the bag connector (E) onto the chipper by rotating the connector until locked in. SEE FIGURE 10
7
ASSEMBLY